///////////////////////////////////////////////////////////////////////////////
                    Ti Setup Tools Software Ver4.4.6
                                                                     
        Copyright(C) 2019 Nikon Corporation All rights reserved.          
///////////////////////////////////////////////////////////////////////////////

1. Introduction
  Thank you for using the Ti Setup Tools Software.

2. Operating environment
  Windows 7 Professional 32bit(English/Japanese/Simplified Chinese) Service Pack 1
@Windows 7 Professional 64bit(English/Japanese) Service Pack 1
  Windows 10 Pro(English/Japanese)

3. Installation
  Double click on "Setup.exe".
  During installation you can use [Next] and [Previous] buttons to go next or
  go back between the screens.
  After installation is completed, click on [Finish] button to end the installation wizard.

*Remarks
 Install the application before connecting the Ti microscope system to a PC, otherwise Ti microscope system 
 might not be recognized correctly because the device driver could not be installed.
 In that case, please install the device driver by the following procedure.

 1) Open the Device Manager
     Windows 7: Control Panel -> Hardware and Sound -> Device Manager.
     Windows 10: Right click on "Start" button ("Windows Mark" on the left bottom corner of screen), and select the "Device Manager" on the menu.
 2) Select the Ti microscope system in the "Other devices", and select "Action -> Scan for hardware changes" menu.
 3) Windows OS searches the appropriate device driver and install it.
 4) "Nikon USB Microscope" appears in "Imaging devices".

4.  Usage
  Please refer to the instruction manual (M478_E8.pdf) of the Ti Setup Tools Software. 

5. Uninstallation
  To uninstall the Ti Setup Tools Software (to remove it from the hard disk),
  run the "Add/Remove Programs" of the PC (see inside Control Panel). 
  Choose "Nikon Ti Microscope Setup Tool" from the list, and click the Remove button.

6. Note
  When 200x instead of 25x is displayed in the magnification list box of the new objective lens registration screen, exit this application once. 
  Please run TiClearCacheData.bat which is in the installation folder and then start the application.